8.1HD/ALLISON

Took the dump trailer and a load of scrap metal from the farm to the scrap yard today.

Cousins Kubota, doing some work at the farm.

Hauled a bunch of dirt for the driveway, now to push it all level.

Brought this little jewel home yesterday from an auction. Picked it up for $325. Less that half price new and old enough it still has cast iron transmission.

Had similar experience with an lg dehumidifier. I will never buy another lg product again.

I passed through ryans area! Bored at a hotel in peru, in. Got a sweeper maintence and troubleshooting class tomorrow. Yay! Lol [emoji15] [emoji379]

Dont need to. If i remember it had a big long hex shaped portion before the threads started. You can cut that end off and still reuse it? Unless they changed from what i remember. The one i remember was a 2000 though?

Cut the non threaded part of the bolt off and it will come out easier, if i recall corectly.

Taurus pt111 or glock 19. Depends on what im wearing.

Ouch. I just paid plates and it was $60-70. Not too bad.

Time to start firewood for next year.

Yes normal on work trucks. I had it on a previous truck and loved it. Have carpet now and its so much harder to clean. Maybe not an issue for some, but i use my truck mainly for work and seems like its always filty.

Nice kill and good looking gun there wormy! I have been debating a free float handguard on my Bushmaster for a while and finally pulled the trigger lol. Went with a Midwest Industries ss-series extended carbine guard, going from standard carbine length to 10 3/16 extended carbine. Think I have everything I need, new to modding this deep, I ordered a new low pro yankee hill gas block, gas tube roll pin, end cap for guard, spanner wrench for jam nut and a upper vice block. Ordered a BAD lever too, wasn't sure on that one, but for $25 what the heck. Any advice feel free to chime in! I have to get some pics when I get it done. Up until now I have polished the sear, replaced trigger spring with a set of JP springs, added a Mako magwell grip, single point sling adapter, and topped it off with an Eotech 516 and g33 Magnifier. Update: here is a before and after pic of the MI free float handguard. I definately like the feel of this one better than the stock. Was a quick and simple install, less than an hour. Good quality product, nice fit and feel.

Worked 18 hours out of last 24. Going to bed. Snow can quit anytime!

Took the wife and little boy to a gun show and local gun shop to pick up a few supplies.